The concept EZ: NC is the result of many years of experience and reflection to achieve two objectives: facilitate the implementation of the entire electronics of a CNC machine and reduce and even eliminate wiring errors .
To do this we will remove most of the cables and replace them with connections based connections RJ11 6 points.
We will connect the power amps in a single cable including all signals including limit switches and connect extensions such as displays, input/output expansion, analog input, jogpad on the EZ:NC Bus.
This range includes two types of extensions:
EZ/NC extension for power amps
Each module supports a power stage, has a screw terminal block for power, a RJ11 EZ: NC and a DB9 connector providing the 4-phase for a bipolar motor as well as signals for a reference switch working under 24V (electronics required is included on the board).
The main point is that simply connecting the PulseMaker II and EZ: NC power with a RJ11 cable to wire the machine. For example:
Here we have a module G251 and a module G250. It remains
to connect USB to PulseMaker II, connect power supply to
modules and connect the machine on the DB9, and it's all!
There is as a full range of modules EZ: NC Power:
If none exist for your power amps, contact us, we will create it.
Here is an example of implementation with modules EZ: CN G250 in video:
Within 15 minutes of wiring the electronics of a CNC machine is finished
Changing a power amps module by another is very easy with EZ: NC:
EZ:NC concept has a second side:
EZ:NC Bus extensions.
The PulseMaker II has an EZ:NC Bus connector, it is the other side of our concept EZ:NC. It again offers a simple solution for connecting extensions at a glance and without error. A simple RJ11 cable and voila.
In addition, each EZ: NC Bus can be chained with the other. Here, for example an extension 8 I/O and an extension LCD:
Two examples of existing modules EZ:NC Bus:
| 8 I/O 24V Extension
|| LCD Display Extension